How To Change Starter On A 1999 Toyota Carolla Youtube

How to Change the Starter Solenoid in a Toyota

by Zyon Silket

garage prototype by Gerd Reiber from Fotolia.com

A Toyota possessor may decide to supervene upon the entire starter if the solenoid needs replacing. They do so because the starter has to be taken out to remove the solenoid. Just considering the solenoid is bad, notwithstanding, doesn't hateful you have to incur the price of replacing the whole starter. Later all, replacing the solenoid simply means you just take to remove two more bolts. That'southward not a lot of piece of work for the corporeality of coin you lot can save past not replacing the starter motor, too.

Step ane

Identify the Toyota on a set of front end end ramps and secure the emergency brake. Place a wheel chock backside the rear tire to prevent the Toyota from rolling astern while y'all are nether it.

Step 2

Disconnect the negative bombardment cable from the battery. Disconnect the positive battery cable from the battery. Wrap both connectors with store towels to prevent them from accidentally touching the bombardment terminals.

Footstep 3

Locate the starter. On side-mounted engines, the starter is behind the forepart half-shaft axle on the passenger side. On standard front-mounted engines, the starter is connected to the driver-side lower half of the engine.

Stride iv

Remove the wire-retaining nut from the large, black wire that secures the wire to the starter casing. Apply a boxed wrench to remove the commodities.

Step v

Divide the wiring harness from the starter solenoid. Squeeze the release tab in the heart of the harness connector and pull the connector off the solenoid.

Step half dozen

Remove the two bolts that secure the starter to the engine cake and pull the starter out of the engine. Use a boxed wrench or socket set to remove the bolts.

Footstep vii

Remove the 2 bolts that secure the starter solenoid to the starter. Pull the solenoid off the starter. Use a boxed wrench to remove the bolts.

Step 8

Place the new solenoid onto the starter and commodities it into identify.

Step nine

Slide the gear located on the terminate of the starter into the engine. Line up the bolt holes and secure the starter to the engine with the original bolts.

Pace 10

Reconnect the wiring harness to the starter solenoid. Button on it until it clicks into place.

Step 11

Secure the large blackness wire to the threaded post on the starter and bolt information technology into place with the original wire-retaining nut.

Reconnect the positive battery cable then the negative bombardment cable.

References

• "Toyota Camry Repair Manual Years 2002 to 2006"; Max Haynes; 2007
• "Toyota Celica Front end-bicycle Drive Repair Manual Years 1986 to 1999"; Haynes: 2000
• "Toyota Matrix & Pontiac Vibe Repair Manual Years 2003 to 2008"; John Haynes: 2009

Things You'll Need

• Front end end ramps
• Wheel chocks
• Shop towels
• Boxed wrench set
• Socket set (optional)
• Replacement solenoid

Writer Bio

Since 2006 Zyon Silket has been writing for companies such as SEOWhat, L&C Freelancing and T-Mobile Wireless. He has extensive experience working in supervisory roles within the wireless and Cyberspace technologies fields. Silket is pursuing a Bachelor of Arts in business direction and network technologies at Lehigh Carbon Community Higher.

More than Articles

Source: https://itstillruns.com/change-starter-solenoid-toyota-6759295.html

Posted by: morristhadell.blogspot.com

Share this post